Home > Error Code > Tandberg Vod Error Codes

Tandberg Vod Error Codes

Contents

The data that did fit was returned. Following are situations which may require the Device Configuration to be run: Removing hardware and reinstalling Updating firmware in the tape drive or library The software is unable to see the Look to the software or SCSI Bus for further troubleshooting. What are your methods of doing Backups of a Windows PC? [Microsoft] by koam331. Source

Please contact that software vendor directly for support. CMOD-56002 VUS Entitlement ServerError Displayed when purchasing a package and the Upsell Server has lost its connection to the Entitlement Server. ERR-24 LSC_IMP_LIMIT Subscriber attempted a VCR command, however the pump reported that the operation failed because an implementation limit was reached. It is important to use the drivers supplied by that vendor.

Rcn Error Codes

VM-2 VM_ERROR_TUNE_RETRY The client attempted to tune a streaming VOD video or the barker channel however the first attempt to tune it has failed. SRM-24 RspSeProcError This is most likely due to ITV server experiencing procedural error during SRM session setup. SRM-8016 RsnItvFreqModMismatch The viewer attempted to watch a VOD video and the VOD server successfully created the session, however the client closed it immediately because the stream failed the frequency validation. SCSI Bus The following situations are related to the SCSI Bus and the vendor for the specific piece of the SCSI bus in question should be contacted directly: Check Event Viewer

Installing drivers Most backup utilities include drivers developed by the software vendor. VODLIB-4 Viewer attempts to start a session, and box is disconnected. ERR-1 This error is most likely generated by CMOD client component signifying a FileNotFound condition. Tivo Vod Error 13 The client will go on to retry the tune after the error message is displayed.

SRM-9006 RspNeCasFailure The asset cannot be played because there was a conditional access failure. Suddenlink Vod Not Working ERR-26 LSC_NO_RESOURCES Subscriber attempted a VCR command, however the pump reported that the required resources were not available to perform the request. SRM returned error 36889 in the session set up response. http://help.suddenlink.com/television/Pages/VODErrors.aspx?product=DVR can you ping this ip from VCS?

The tool tests the write / read functions of the drive outside of the backup software and driver. Status Code 225 Suddenlink was it a public ip? CM-14 LSC_NO_PERMISSION The subscriber attempted to perform a VCR command on a VOD stream, however the pump returned error 0x14, stream operations are not allowed. and on expressway call setup mode should be "direct".I think this could be issue with media ports as well, as i see a proceeding coming from the remote end.

Suddenlink Vod Not Working

Pick 'n Pay TV [CanadianBroadband] by Not Dead Yet432. ERR-32774 eRsnItvOtherError Request from converter to shut down stream under error. Rcn Error Codes Save the log file that is produced from that test and contact Tandberg Data Technical Support for analysis. Suddenlink Error Code S0a00 Pay attention to the error mode and error codes.

Backup sets are a function of the software. this contact form CMOD-54001 MsoD Device NotFoundError The MSO server is indicating this device is not part of its database or device is not associated with the locality. It is in indirect mode. Please try the request again. Rcn On Demand Service Error

CMOD-55025 Credit CheckError The view attempted to purchase a package online, but the request was denied due to a credit problem. Please contact Suddenlink Customer Service so we can help resolve this problem. ERR-36893 RspSeExAssetError Subscriber attempted to start a VOD session. have a peek here Now, on almost a daily basis (sometimes more than once a day) I get OnDemand system errors whenever I scroll through a list or simply try to access the OnDemand system.So

CMOD-56001 VUS Upsell Server Error Displayed when purchasing a package and Mod-Lite has lost its connection to the Upsell server. Suddenlink Error Codes Slot where the controller card is installed Controller driver Cable Terminator SCSI ID conflicts with other devices on bus or with device and controller IRQ conflicts between controller card and other Source port on VCS 15020 to destination port 1720 is opened, but need to know if the packet or call setup actually made it to the endpoint to confirm it received

The MSO has determined that the subscriber is currently viewing this asset on another converter and is not authorized for multiple concurrent viewings.

ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.10/ Connection to 0.0.0.10 failed. What is the remote end and whether it receives the setup or not is the most important part!!ThanksAlok See More 1 2 3 4 5 Overall Rating: 0 (0 ratings) Log SRM-9004 RspSeInternalError This is usually due to MOD internal error. Suddenlink Status Code 228 The request was rejected because the external authorization service denied the request based on the asset.

Example: trying to FF/REW if video session is not open. There was a server failure. If the NPT is not set to be the beginning of stream, this error is returned. Check This Out ERR-21 Subscriber attempted a VCR command, however the CM reported that a bad parameter was supplied in the request.

SRM-20 RspSeNoResource The subscriber attempted to start a VOD session. Each of these pieces is supported by their respective manufacturers and they should be contacted directly. VM-4 VM_ERROR_CLIENT_DISCONNECTED Viewer attempted to open a session and set top is disconnected. Generated Wed, 07 Dec 2016 22:15:41 GMT by s_wx1079 (squid/3.5.20)

Either there are no servicing instances in the server list file or the client attempted to contact all available instances and there was still no response from the server. The tape drive must be installed properly and in good working order. Many times the event will list specifically what piece of the bus is causing the failure. ERR-7 Invalid Parameter The call to the CMOD Library failed because an invalid parameter was supplied.

ERR-18 The CM could not perform the requested VCR command given the current state. VM-5 VM_ERROR_CLIENT_DISC_WHILE_PLAY Set top disconnected while watching a VOD video.